Chapter 2: Getting Started & Adjusting the Display 2-5
Simulator Mode
reaches zero a beep sounds, and the display unit switches off. Release the
POWER key.
Note: Switch the display unit off before you remove the power cord.
Figure 2-4: Switch Off
Note: You do not need to change to Standby mode before turning off the dis-
play: if you turn the radar display off while it is in Transmit mode, the scanner
is also de-activated.
Simulator Mode
When simulator mode is on a simulator database box is displayed.
When the display is switched off then on again, simulator mode is maintained.
It is recommended that you select the System Set Up Menu and switch off
simulator mode when you have finished.
➤ To view simulated image:
1. Press MENU followed by the
SYSTEM SET UP
soft key.
The set up menu pop-up is displayed.
2. Use the trackpad to move the selection bar over the option
SIMULATOR
. The
simulator soft keys are displayed.
3. In the system set up menu, press
RADAR
to view a simulated radar image,
DATA
to view the chart display with simulated position, or
BOTH
to view
simulated fishfinder and chart data
4. Press ENTER twice to return to the default display.
Note: Any waypoints placed on the chartplotter in simulator mode are re-
tained in the database list and are available for use in routes.
DISPLAY
GAIN
VRM/EBL
MULTI
MARKS
ALARMS
RANGE
ENTER CLEAR MENU
POWER
Countdown timer:
number of seconds
to power off
SECONDS
3
D3599-1
POWER OFF IN
3s
MENU
SYSTEM
SET UP¬
To Next Page
Loading...
