102
HSB Series LCD Display
Follow a Route
Note: The current route may have been created on this display, or created on
another unit and received on this display via SeaTalk.
If a route has been reversed or if a route on screen was being followed but
stopped before completion, the target waypoint – outlined by a square box –
may be different to when the route was created.
You should always check the target waypoint before initiating a follow route.
➤ To follow the current route:
1. Press the GOTO default soft key. The Goto/Follow soft keys are displayed.
2. Press the FOLLOW ROUTE soft key.
Alternatively, to follow a route:
Place the cursor over a route leg until the letters RTE and the route soft keys
are displayed then press FOLLOW ROUTE.
Your vessel’s current position becomes the origin, and the target waypoint in
the current route becomes the active target.
The soft keys change as follows:
D4251_1
CLEAR
ROUTE
REVERSE
ROUTE
EDIT
ROUTE
STOP
FOLLOW
These options are described in the following sections.
➤ To follow the current route in reverse:
1. Press the ROUTE default soft key, followed by MORE. The route soft keys are
displayed.
2. Press the REVERSE ROUTE soft key. The current route is reversed on the
screen. Press ENTER or CLEAR.
3. Press the GOTO default soft key. The Goto/Follow soft keys are displayed.
4. Press the FOLLOW ROUTE soft key.
Alternatively:
Place the cursor over the route leg until the letters RTE and the route soft
keys are displayed. Press REVERSE ROUTE then FOLLOW ROUTE.
Your vessel’s current position becomes the origin, and the target waypoint in
the current route becomes the active target.
The soft keys change as follows:
D4172-1
RESTART
XTE
WAYPOINT
ADVANCE
GOTO
CURSOR
STOP
FOLLOW
These options are described in the following sections.
FOLLOW
ROUTE
FOLLOW
ROUTE
GOTO
REVERSE
ROUTE
GOTO
Follow a Route
Target Point Arrival & Alt
To Next Page
Loading...
