Chapter 7: Setting Up the System Defaults 135
STC Preset
The Sensitivity Time Control can be adjusted to equalise targets levels across
the display. The factory setting should provide an even display, but if you find
that targets are brighter or dimmer nearer the centre than at the edge of the
display, you can adjust this slider until the required display is achieved.
Note: Caution should be observed when adjusting this parameter as poor
adjustment can adversely affect auto gain and sea controls.
Tune Preset
The radar tuning is controlled either automatically or manually using the TUNE
control (see Section 3.3). However, this only controls a restricted range of
tuning values. If the actual tuning peak falls outside this range, you will need to
adjust the Tune Preset slider to move the controlled range over the tuning peak.
Press the INITIATE SET UP soft key to enable slider control, and adjust for
maximum image intensity.
If required, you can press the RESTORE PREVIOUS soft key to reset the Tune
Preset to the value before you pressed INITIATE SET UP.
Advanced
Radar Settings
To Next Page
Loading...
