Chapter 2: Getting Started 23
Otherwise, the display shows the selected chart area and any data that were
displayed when the display was last used.
DISPLAY
RANGE
MARKS
VRM/EBL
ALARMS
GAIN
SEA
MULTI
MOB
ENTER CLEAR MENU
POWER
D4187-1
Until unit beeps
➤ To switch the display off, press and hold the POWER key for three seconds. A
countdown timer is displayed; when it reaches zero a beep sounds, and the
display and the key back-lights go off.
Note: Ensure you switch the display unit off before you remove the power cord.
Simulator Mode
When simulator mode is switched on a simulator database box is displayed.
When the display is switched off then on again, simulator mode is maintained.
It is recommended that you select the System Set Up Menu and switch off
simulator mode when you have finished.
➤ To view a simulated radar and chart image:
1. Press MENU followed by the SYSTEM SET UP soft key. The system set up
menu pop-up is displayed.
2. Use the trackpad to move the selection bar over the option SIMULATOR. The
simulator soft keys are displayed.
3. Press either RADAR to view a simulated radar image, DATA to view the chart
display with simulated position, or BOTH to view simulated radar and chart
data.
4. Press ENTER twice to return to the default display.
Note: Any waypoints placed on the chartplotter in simulator mode are retained
in the database list and are available for use in routes.
SYSTEM
SET UP!
RADAR
DATA
BOTH
Simulator Mode
To Next Page
Loading...
