Chapter 1: Overview 15
The cursor is used to:
• Select a position on the screen.
• Select an item, e.g. guard zone on the radar, chart object on the chartplotter.
• Select an area of the radar image to zoom into or pan the chart display.
Moving the Cursor
You can press on any of the four sections of the trackpad to move the cursor in
that direction (up, down, left or right), or press two sections at the same time to
move diagonally. The cursor moves faster as you continue to press the trackpad.
The current cursor position is shown in the cursor data box (if selected).
Note: During many operations you cannot move the cursor around the screen;
if you cannot move the cursor using the trackpad, check the default soft keys are
displayed (unless they have been switched OFF in system set up). If not, press
ENTER until they are displayed.
The cursor is normally displayed as a crosshair. However, if you have not
moved the cursor for more than five seconds, when you next move it the cursor
is outlined by a circle so it is easier to locate on the screen.
Context-Sensitive Cursor Control
The cursor is context-sensitive. When the cursor is positioned over special
features on the display a text label appears to identify the feature as follows:
Text Label Feature Radar/Chart
BOX Data box (any type) Both
MRK Radar Mark Both
MOB Man Over Board marker Both
WPT Chart Waypoint Both
CTR Centre of radar Radar
FLT Floating EBL/VRM Radar
GRD Guard zone Radar
SHM Ships Heading Marker Radar
VRM/EBL VRM and EBL, 1 or 2 Radar
ZMB Zoom box Radar
A-B Ruler line Chart
COG Course Over Ground vector Chart
Operating Controls
To Next Page
Loading...
