THINGS TO DO BEFORE CONNECTING
COMPON ENTS
Protect your components from power surges
• Connect all components before plugging any power
cords into the wall outlet.
• Always turn off the TV and/or component before you
connect or disconnect any cables.
Position cables correctly to avoid audio hum or
interference
• Insert all cable plugs firmly into their jacks.
• Place the audio/video cables to the sides of the TV°s
back panel instead of straight down the middle after
you connect your components.
• Try not to coil any twin-lead cables and keep them
away from the audio/video cables as much as possible.
• Make sure all antennas and cables are properly
grounded. Refer to the Safety Tips sheet packed with
your TV.
Protect your components from overheating
• Do not block ventilation holes in any of the
components. Arrange the components so that air can
circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier on the top shelf of the stand so
heated air rising from it will not flow around other
com ponents.
Connect audio/video cables for best results
• Required for picture-in-picture feature
Important:
This section assumes that you
have already used the Interactive
Setup and programmed the
remote
• : j
55
To Next Page
Loading...
