Blank screen
• Maybe the device connected to the input jacks is not turned
on.
• Try another channel.
• Press RESET, in case the picture controls are set too low.
No sound, picture okay
• Maybe sound is muted. Try pressing volume up button to
restore sound.
• Maybe TV's speakers are turned off. Check Speakers On/Off
function.
• If using an component with S-Video output, remember to
also connect the component's L and R AUDIO OUT jacks to the
TV's L and R INPUT 1 jacks.
• Maybe SPEAKER swit'ch on the back of the TV is not in the
INTERNAL position.
Can't select certain channel
• If using a VCR, check to make sure the TV/VCR switch on the
VCR is in the correct position.
Noisy stereo reception
• May be a weak station. Use EXPAND button to change to
mono mode instead of stereo.
No picture, no sound but power light is on
• Maybe cable/air function is in wrong position.
• Maybe a vacant channel istuned.
• If watching VCR (connected only through antenna input),
make sure TV is tuned to channel 3 or 4- same as CH3/4
switch on VCR. Also check to make sure TV/VCR switch on
VCR is in correct position.
Sound okay, picture poor
• Check antenna connections.
• Try adjusting sharpness function to improve weak signals.
Black Box appears on the screen:
• Captioning may be turned on. Check the Closed-Caption
Display control panel in the Channel Menu.
73
To Next Page
Loading...
