Verifications for a new assembly
22
102-127108955 V1.1 93/ 102
Verifications for a new assembly
The following points must be checked:
Base fixing Is the DFA 127 securely fixed to the backing construction?
Chassis Is the attachment still ok?
Door hinge Can the door leaf be moved smoothly?
Door leaf Do the leaf weight and the leaf width correspond to the defaults in accor-
dance with the diagram in this manual?
Arm Has the fixing screw of the arm been firmly tightened?
Function Does the movement of the door give reason for dissatisfaction?
Electric supply Is the outer sheathing of the supply cable intact up to the mains adaptor
cover?
Wiring Are all cables connected and have the clamping screws been firmly tight-
ened? Are all the connection assemblies to the motor in order?
Control unit connection Was the prescribed cable used and has it been installed correctly?
Configuration Was the operator configured in accordance to the default?
Was the configuration sheet filled out and placed under the operator's cas-
ing?
Calibration run Has a calibration run been completed?
Control unit Functional check of all operation modes
Actuating devices Adjustment and functional test of motion sensors, push button, pull-switch,
etc.
Safety elements Adjustment and functional test of safety cells on door leaves
(SIO / SIS)
Safety functions Check external connections (EMERGENCY STOP / SSK).
Electrical door lock Does the electrical door lock have enough free motion?
Is the diode fitted over the door lock connection?
Functional test of the electrical door lock and the monitoring
Casing Have the casing and the side cover been installed properly?
Logo Is the record logo correctly attached?
22
To Next Page
Loading...
