LONG ROLLER SHAFT
TRACK UPPER LIMIT
ROLLER CENTERED
BETWEEN LIMITS
AS SHOWN
TRACK LOWER LIMIT
ROLLER
M4 x 6mm CONEPOINT SET
SCREW MUST BE TIGHTENED
INTO SHAFT GROOVE
SECTION A
ROLLER TRACK
CROSS-SECTION
SET SCREW DETAIL
Make sure Pull track is installed level with the header. This is to ensure the roller stays
inside the track during opening and closing, prolonging the life of the roller.
3.3 Universal Arm
Universal arm can be used as both push and pull arm, allowing flexibility to
mount the HA8 on either side of the door opening.
PUSH APPLICATION PULL APPLICATION
DOOR 'PUSHED' OUT DOOR 'PULLED' OUT
Pg. 26
HA8-SP Manual V. 7.0
Record Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@recorddoors.com
www.recorddoors.ca
Record USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@recorddoors.com
www.recorddoors.com
To Next Page
Loading...
