66
CAMERA DOES NOT HOLD STEADY
1. If in the air, wait 30 seconds. The gimbal will
automatically try to stabilize itself.
2. Restart the Teal 2 by powering it off and then on
again.
3. Make sure that there are no obstructions or debris in
the gimbal payload.
The camera payload on the Teal 2 “flops” and will not
hold stable.
A BATTERY PACK SHUTS OFF AFTER AN ATTEMPT TO
POWER ON
A battery pack that is NOT connected to a Teal 2 or TAC
immediately shuts off after an attempt to power it on.
This is normal behavior. The battery pack will remain
powered on once connected to a Teal 2 or TAC.
A battery pack that is connected to a Teal 2 or TAC will
not power on or immediately shuts off after an attempt
to power it on.
1. Attempt to charge the battery pack:
Tap the power button once.
Insert the DC power cable into the charger and plug the
AC power cord into an AC outlet.
Insert the battery pack onto the charger.
Verify
that the green LEDs on the battery pack are
illuminated to indicate the battery pack is charging.
2.
If the attempt to charge is unsuccessful, please
contact Teal Drone Customer Support:
(385) 281-8415
SUPPORT@TEALDRONES.COM
1. Make sure that the battery pack is powered on and is
fully charged. The drone will not arm when the battery
pack charge level is 20% or less.
2. If in Position Flight Mode, you may not be connected
to a sufficient number of satellites to be able to
triangulate the position of the vehicle. It is critical to
have at least eight (8) but recommended that ten (10)
satellites are indicated on the GPS ico
takeoff.
The Teal 2 will not arm using either the arm button or
soft key commands.
To Next Page
Loading...