page 15 of 91 USB-QFLCII-14804/0
2.5 Warranty
REMBE
®
warrants that the unit complies with the relevant German and European Regulations as
listed on the Manufacturer's Certificate. Specific regulations of the customer's country may not
have been taken into consideration because the manufacturer may not know the location of the
end user.
Our warranty does not include damage resulting from wear and tear, corrosion, pyrophoric or
internal and external chemical influences, improper handling, installation, operation and any
use other than intended originally (please see Section 2.3 Intended use).Fire and explosion
are excluded from warranty.
Warranty conditions
Warranty conditions to be observed by the system operator are as follows:
• Loading and shipping in accordance with REMBE
®
instructions
• Proper storage before installation and commissioning
• Knowledge and implementation of the information, notes and references in
the operating manual
• Expert installation, commissioning and repair to the extent these services
are provided by the customer himself.
• Proper operation
• Compliance with operating parameters, such as
- dust type or additives
- dirty air dust volume
- dirty air temperature
- dirty air dust concentration
- dew point within dirty air
- air flow velocity
• Operation with intended and proper protection devices/systems
• Operation without modification to inlet isolation device
• Observing the service and inspection intervals, with service and inspections
completed by trained personnel. Any work performed is to be recorded in a
record log.
• Use of original spare parts only
• In the event of a defect or malfunction, and for its immediate and expert
handling, we ask you to notify REMBE
®
, Inc. or your REMBE
®
representative.
If exceptions have been agreed upon in contractual documents, the
conditions stipulated in those documents shall apply.
Expiration of warranty
Warranties are voided in the event of non-compliance with above-
mentioned conditions, in
the event of natural disasters and/or acts of God.
To Next Page
Loading...
