page 52 of 91 USB-QFLCII-14804/0
9 Maintenance
Section 3, Safety must be read completely prior to all maintenance work.
Please follow the instructions given!
In addition, maintenance should be performed on other system
components that are listed in separate operating manuals.
----------------------------------------------------------------------------------------------------------
Information in the
Maintenance schedule Information concerning maintenance work and frequency are only
recommendations because the manufacturer has no long-term experience
with the operator's specific operating conditions. Information within this manual
is to be supplemented by your own experiences.
Maintenance cycles refer to 1-shift operation
Maintenance log Inspection and maintenance work are to be recorded in a log book that
can be requested by REMBE
®
. When replacing parts, please note part
serial number and date of replacement.
Service agreement With a service agreement, you will receive extensive, rapid and
reliable system supervision by a REMBE
®
Certified Service
Contractor. Contact your local REMBE
®
, Inc. representative or
REMBE
®
, Inc. for more information.
9.1 Safety during maintenance and inspection
Preventive and thorough maintenance is essential for the safety of the
staff within working range of the process. In addition, it ensures proper
operation of the system. Please have only qualified personnel perform
inspection, maintenance and service work!
Maintenance intervals Information concerning maintenance work and its frequency are only
recommendations because the manufacturer has no long-term experience
with the specific operating conditions of the facility. Information within this
manual is to be supplemented by your own experience.
----------------------------------------------------------------------------------------------------
9.2 Preparation for inspection/maintenance work
Before performing any inspection/maintenance work, please take the following steps:
Preparation for
Inspection/Maintenance-
related work
• Inform operating staff in a timely manner of the upcoming maintenance work.
• Appoint a person in charge.
• Let the system run for approximately 1 minute without feeding the substances that
are to be separated, that is, turn off the processing machine to be exhausted.
• Disconnect the air pollution control system.
• Since overrunning may occur, wait until all rotating parts have stopped. We
recommend waiting another 5 minutes prior to opening the inspection lid just to be
sure all parts have stopped completely.
• Please refer to Section 3.10, Safety during maintenance and inspection
----------------------------------------------------------------------------------------------------
To Next Page
Loading...
