page 36 of 91 USB-QFLCII-14804/0
WARNING
In the event that the level sensor signals deposit accumulation, the
entire inlet isolation device must be inspected!
Orderly functioning of the inlet isolation device cannot be guaranteed unless
it has been inspected for deposits!
-------------------------------------------------------------------------------------------------------
WARNING
The level sensor does not eliminate the need for inspection
and maintenance at regular intervals!
Preventive and thorough inspection and maintenance is essential for
the safety of personnel working within range of the inlet isolation
device. In addition, preventive and thorough maintenance ensures the
proper operation of the system. Please have only qualified staff perform
the inspection,
Information and specifications regarding maintenance work and its intervals
stated in the operating instructions
are only recommendations. The
manufacturer does not have practical, long-term data under the specific
operating conditions of each customer. The information stated in the
operating instructions is to be supplemented with your own practical
experience
-------------------------------------------------------------------------------------------------------
4.4 Monitoring panel requirements
NOTE: THE Q-FLAPCOMPACT II/Q-FLAPCOMPACT II PLUS
REQUIRES controls or a properly programmed PLC.
REMBE
®
, INC. CAN PROVIDE A MONITORING PANEL OR YOU MAY
SOURCE YOUR OWN. See Section 12 Annex: Sequence of Operation
with REMBE
®
monitoring panel.
To Next Page
Loading...
