EasyManua.ls Logo

REMBE Q-FlapCompact II - Operational and Environmental Hazards

REMBE Q-FlapCompact II
91 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
page 18 of 91 USB-QFLCII-14804/0
3.4 Health hazard due to exhausted substances
WARNING
Airborne dust, mist or vapor that may be inhaled or otherwise
result in direct contact with airborne materials can be a health hazard
Please provide protective equipment for the operating staff such as:
a) Safety glasses
b) Hearing
protection
c) Gloves
d) Protective clothing
e) Full face masks with appropriate filter cartridges (protection class
depending on specific dust hazard)
---------------------------------------------------------------------------------------------------------
WARNING
Alterations to the system, to ductwork or to the adjustments of inlet
isolation devices may cause pressure loss. Inadequately exhausted
substances can endanger the health of personnel! Therefore, alterations should
only be carried out after consulting REMBE
®
.
---------------------------------------------------------------------------------------------------------
3.5 Danger of crushing and overturning
To avoid the risks mentioned below, this inlet isolation device should not be
operated until assembly has been completed. This device should only be
serviced when the system has been shut down.(see Section 3.1 Safety
instructions during
maintenance)
hazard near the inlet
Isolation device
WARNING
There is a danger of physical harm to personnel near the device.
The system should be operated only after the ductwork has been connected and
the inspection lid has been closed so that the dangerous area cannot be reached
with the extremities.
Do not operate this inlet isolation device while the inspection lid is open!
---------------------------------------------------------------------------------------------------------------

Table of Contents

Related product manuals