REMBE Q-FlapCompact II - EC Declaration of Conformity; ATEX Compliance for Explosion Protection; Applied Harmonized Standards

page 3 of 91 USB-QFLCII-14804/0
EC Declaration of Conformity
We
hereby declare that
Q-FlapCompact II/Q-FlapCompact II Plus back pressure flap
corresponds explosive decoupling of the following EU directive, harmonized standards and
technical specification as far as services provided by the customer have been carried out
according to our reg- ulations, mentioned directives and standards and operation of the
back pressure flap in accordance with the intended use:
94/9/EC (ATEX 95) System and explosion protection systems for application in explosion endangered areas
Labelling protection system (DN 140 - DN 1000) 1026 D St1
Labelling protection system (DN 140 - DN 315) 1026 D St2
Labelling system (only for ProFlapII-St1) II 3D c T
60°C EC-type examination FTZU 07
ATEX 0008X Quality management production: FTZU 07
ATEX Q 003
Following harmonized standards and technical specifications have been applied:
prEN 16447 Back pressure flaps for explosive decoupling, last update: 09/2012
EN ISO 80079-34 Explosive areas - part 34: application of quality management
systems for the system fabrication
EN 61241-14 Electrical operating agent for application in areas with
combustible dust, part 14: selection and construction (VDE
0165-2)
prEN 13463-1 Non-electric systems for application in explosive areas - part 1:
Basis and requirements, last update: 05/2007
EN 13463-5 Non-electric systems for application in explosive areas - part 5:
Protection by constructive safety "c"; last update: 2005/03
TRBS 2153 Technical rule for operational safety "Avoidance of ignitions
because of electrostatic charge"
Kirchheim, 05.12.2012
i.V.
i. V. Dipl. Ing. (BA) J. Kuhn
Head of Quality Management
Keller Lufttechnik GmbH
+ Co. KG Neue
Weilheimer Straße 30
73230 Kirchheim unter Teck