C - 11
REVISION HISTORY R8C/20 Group, R8C/21 Group Hardware Manual
0.20 Jun 28, 2006
377
Figure 19.4 OFS Register revised.
379 19.4.2 EW1 Mode, on the 3rd line
;
“Do not execute software command ~” → “Do not execute command
~” revised.
380 19.4.2.1 FMR00 Bit, on the 1st line
;
“(including suspend periods)” added.
381 19.4.2.16 FMR47 Bit revised.
382
Figure 19.5 FMR0 Register;
NOTE6 added.
384
Figure 19.7 FMR4 Register;
NOTES revised.
385
Figure 19.8 Timing of Suspend Operation revised.
389 19.4.3.4 Program Command, on the 5th line
;
“The FMR00 bit is ~ completes.” → “When suspend function ~ auto-
programming completes.” revised.
390
Figure 19.13 Program Command (When Suspend Function Enabled)
added.
391 19.4.3.5 Block Erase, on the 11th line
;
“The block erase ~ program suspend.” → “Do not use ~ program-
suspend” revised.
392
Figure 19.15 Block Erase Command (When Erase-Suspend Function
Enabled) revised.
393
Table 19.5 Status Register Bits, Value after Reset of SR7 (D7)
“0” → “1” corrected.
396 19.5 Standard Serial I/O Mode, on the 3rd line
;
“Standard serial I/O ~ interface” → “There are three ~ serial I/O mode
3.” revised.
Table 19.7 Pin Functions (Flash Memory Standard Serial I/O Mode 2)
revised.
398
Figure 19.17 Pin Connections for Standard Serial I/O Mode 3;
“Figure 19.17 Pin Connections for Standard Serial I/O Mode” →
“Figure 19.17 Pin Connections for Standard Serial I/O Mode 3”
revised.
399
Figure 19.18 Pin Processing in Standard Serial I/O Mode 2 added.
Figure 19.19 Pin Processing in Standard Serial I/O Mode 3;
“Figure 19.19 Pin Processing in Standard Serial I/O Mode” → “Figure
19.19 Pin Processing in Standard Serial I/O Mode 3” revised.
401 19.7 Notes on Flash Memory
;
“19.7 Precautions on Flash Memory Version” → “
19.7 Notes on Flash
Memory
” revised.
404 to 423 20. Electrical Characteristics revised.
Rev. Date
Description
Page Summary
To Next Page
Loading...
Need help?
General
