Renkforce RF500 Maker Construction Kit - Page 125

149 pages

Save Page as PDF

To Next Page

To Previous Page

125

The extrusion width for all the different print versions can be set here. The extrusion width is the width of the output plastic thread. E.g., this may

beincreasedattherstlayer,sothatthebottomoftheprintedobjectbecomesdenser.

Main Page

Default Chapter2
- Table of Contents2
1 Introduction4
2 Explanation of Symbols4
3 Intended Use5
4 Safety Notes6
- A) General Information6
- B) Mains Unit6
- C) Set-Up, Site of Operation7
- D) Operation7
5 Feature Description8
6 Working Principle of the 3D Printer8
7 Overview of the most Important Parts9
- A) Maker Construction Kit / Construction Kit9
- B) Preassembled Device10
8 Software and Firmware Installation11
- A) Download and Unpacking of the Software/Firmware Package11
- B) General Information on the Repeater Host Software11
- C) Installation of the Repeater Host Software12
- D) Installation and Updating of the Firmware12
9 Required Tools and Material14
10 Assembly of the Mechanical Parts15
- A) General Information15
- B) Assembly of the Components17
11 Mounting of the Electrical Components57
- A) Installation of the Electrical Components57
- B) Wiring of the Electrical Components71
12 Final Work85
13 First Commissioning87
- A) Assembly Of The Filament Holder87
- B) Preparing and Assembling the Printing Plate Support87
- C) Setup and Transport88
- D) Mains Connection and First Activation88
- E) Adjustment of the Motor Driver89
14 Operation at the Printer90
- A) Display and Operating Buttons90
- B) Menu Overview91
- C) Functions of the Individual Menu Items93
15 Calibration95
- A) General Notes on Calibration95
- B) Setting of the Z-Stop96
- C) Heating to Printing Temperature97
- D) Setting the Printing Plate99
16 Inserting, Removing and Changing the Filament100
- A) Inserting the Filament - Mechanical Part100
- B) Inserting the Filament Via the Printer Menu101
- C) Removing and Changing the Filament106
17 First Print of an Example Object from the SD Card107
18 General Notes on 3D Printing110
19 Software "Repetier-Host111
- A) General Notes on Software111
- B) Installation111
- C) Connection of the Connected Printer112
- D) Manual Operation Via the Software114
- E) Placement of a Printing Object in the Software115
- F) Preparation for Print117
- G) Print119
- H) more Detailed Description of the Slicer Functions121
- I) Setting up Another Slic3R Version129
20 Firmware Update132
21 Maintenance135
- A) General Information135
- B) Cleaning135
- C) Nozzle Change136
22 Troubleshooting138
23 Handling140
24 Disposal140
25 Technical Data140
- A) Printer140
- B) Mains Unit140
26 Annex141
- A) Fine Adjustment of the Filament Infeed141
- B) Setup of the Printer Settings144
- C) Recommended Tightening Torque of the Screws147

Related product manuals

Renkforce RF2000 v2 Series

110 pages

Renkforce RF500 Maker Construction Kit - Page 125

Table of Contents

Related product manuals