Renkforce RF500 Maker Construction Kit - Page 126

126
Filament Settings
(1) Filamentdiameterandlamentdiametertolerancesaccordingtothemanufacturer'sspecicationsaresethere.Ifnomanufacturer'sspeci-
cationispresent,thesevaluescanalsobemeasuredwithacalliper(measure1moflamentmaterialin10differentpointsandthenset
the average here).
(2) Temperaturesettingfortheextruderandheatingbed(inthepreassembleddeviceorwhenusingtheoptionallyavailableheatingplatekit)
separatedbyrstandallotherlayers.
Insomesettings(e.g.PLA),theheatingisdeactivatedbydefault.Ifthisistobeused,thefunctionneedstobeactivatedrstbyset-
ting a temperature.
 Observethesettingsrecommendedbythelamentmanufacturer!
 Sincethebestvaluesmayuctuateextremelydependingonthelamentmanufacturer,performyourowntestsbasedonthepre-
settingstoachievethebestprintingquality.Whenperformingthetests,proceedin5°Cstepsandcomparetheresultsduringorafter
printingwithothersettings.Therstlayershouldalwaysbeprintedalittlemorehotlyforbetteradhesionontheprintingplate.
(1) Hereyoucanchoosebetweenautomaticcoolingandpermanentoperationofthefanattheextruder.
(2) Settingofthefanspeed.
1
2
1
2