Renkforce RF500 Maker Construction Kit - Page 127

127
Printer Settings
(1) Geometricdataoftheprintingplate
(2) Numberoftheextruders
(1) Thestartingcodecontainstherstcommandsthatthe3Dprinterperforms.
(2) Theendcodewillbeperformedattheendoftheprintandcouldcontain,e.g.therunintoaremovalpositionfortheprintedobject.
Detailed information on the G-Codes can be found, e.g., in http://reprap.org/wiki/G-code.
1
2
1
2