Renkforce RF500 Maker Construction Kit - Page 142

142
• Whenthelamentismarked,feedinprecisely50mm.Forthis,
move the mouse over the arrow at the lower left in the right control
(seeredarrow).Whenthemousepointerisallthewayatthebot-
tom(seearrowtipoftheredarrow)andthemiddleshows50,click
precisely once.
• The lament motor now conveys precisely 50 mm lament and
then stops again.
• Nowmeasuretheremainingdistancebetweenthe
ball bearing holder and the mark just as you did
when marking before.
• Inourexample,53.37mmareleft.