Renkforce RF500 Maker Construction Kit - Page 33

33
ThreadtheM5-cylinder-headscrewwithoutwasher(orthecylinder-
head screw M5x35 with the plastic washer) through the counter-
holder and the right bore of the spring holder into the extruder motor
holder(1).
Foldthespringholderwiththepressurespring(2)ontothewasher
placedbeforewasher(3).
Now push the M5-cylinder-head screw with the washer into the left
boreofthespringholder(4).
Push the spring holder with the pressure spring (1) including the
washerintothecorrespondingboreoftheballbearingholder(2).Now
threadthecylinder-headscrew(3)throughthe
left bore of the extruder motor holder.
1
2
4
3
3
1
2