58
1x heating cartridge
1x cylinder head screw M3x10
1x heating block
Insert the heating cartridge into the corresponding opening from
above(oppositeofthenozzle).
Secure the heating cartridge with the cylinder-head screw as illus-
trated.
1x nozzle stock
1x PEEK part
1x PTFE insert
1x extruder infeed
1xnutM6(atISO4035)
1x PTFE thread sealing tape
Cut about 2 to 3 cm thread sealing tape off of the roll and wind it
around the short thread of the nozzle stock. Cut off the sealing tape
that protrudes over the thread with a sharp knife, e.g. by running the
knife along the upper-most groove of the thread.
The sealing tape must never protrude beyond the thread.
To Next Page
Loading...
