Renkforce RF500 Maker Construction Kit - Page 59

59
TurnthenozzlestockintothePEEKpartcarefully.Itwillonlytinone
side because the opening is larger on the other side.
Tighten the nozzle stock hand-tight with a 13 mm spanner.
Push the PTFE insert into the PEEK part. Take a hexagon socket
wrench with at least 3 mm and push the PTFE insert entirely into the
PEEK part.
Carefully turn the extruder inlet into the PEEK part and tighten it man-
ually as far as possible.
Screw the M6-nut onto the thread of the nozzle stock to the stop.
Please observe that the nut in the delivery is a little lower than in the
gure.