Repak RE20 - Procedure 3: Preparing Machine for Operation

133
No.
daily
weekly
monthly
Action
Remark
22
X
Spray the machine with an alcohol-based
disinfectant.
Follow the instructions in
paragraph 6.1.
23
X
Check the machine for induced rust and
remove it if present.
See paragraph 6.1.
Procedure 3: Preparing the machine for operation
Tools required:
- Screw driver
No.
Action
Remark
1
Replace all components that have been
removed.
-
2
Replace all safety covers and protective
systems.
See paragraph 2.4.3 for
positioning the side plates.
3
Press the Re-set button.
-
4
Press the ‘washing setting’ button. The
machine turns the washing procedure off.
The working systems open automatically.
See paragraph 6.1.2.
5
The machine is now ready to operate. If so
desired, the machine can now be turned on.
See paragraph 5.2.
Figure 6.4 RE20
1.
1.
2.
1. safety covers
2. side plates