Repak RE20 - Procedure 2: Daily Cleaning and Maintenance

132
No.
daily
weekly
monthly
Action
Remark
1
X
Remove the protective covers from the
machine.
Place the covers on the
ground because they are
fragile.
2
X
Remove the side plates from the machine.
Place the plates on the ground because
they are fragile.
See paragraph 2.4.3 for
removing the side plates.
3
X
Remove the product support bars and
support tray from the machine.
-
4
X
Clean the product support bars covers and
plates manually with warm water and
cleanser.
Follow the instructions on
the cleanser packaging.
5
X
Blow-dry the product support bars, covers
and plates with compressed air.
Make sure that remains of
waste or water are not
blown into anyone’s face.
6
X
Remove large pieces of waste materials
manually from the machine and the
immediate vicinity.
-
7
X
Remove any waste film from the cutters.
-
X
Treat the entire machine with foam and
allow it to work in for 15 minutes.
Follow the instructions on
the cleanser packaging.
8
X
Rinse the machine carefully inside and out
with warm water.
Manually or mechanically.
9
X
Use the sponge to remove remains of waste
materials from the machine and rinse the
spots once again.
-
10
X
Remove calcium deposits from parts
affected. Use only moderate amounts of
decalcifier.
Follow the instructions
given in paragraph 6.1.
11
X
Clean the decalcified parts thoroughly with
water.
12
X
Remove the film used for cleaning
purposes.
See procedure 6.1, step
11.
13
X
Dry the entire machine with compressed air.
14
X
Allow the transport system to run.
See Chapter 4.
15
X
Blow-dry the transport chain at the bottom
film infeed roll with compressed air.
-
16
X
Check the chain clips for defects. Advise the
Technical Department if necessary.
Visual check.
17
X
Oil the chain with a small brush. If available,
use the automatic chain lubrication system.
See Chapter 4.
18
X
Check the blades in the longitudinal and
cross cutters for breaks, damage and rust.
Visual inspection. Call in
the technical department
if defects are noted.
19
X
Lubricate corrosion-sensitive parts such as
the cutter blades with oil.
Use a small brush.
20
X
Cutting tool : Clean the cutting tool unit.
Use manual of the
detergent.See chapter 12.
21
X
Cutting tool : clean the guide columns and
put a touch of oil on it use FIN FOOD Lube
+ Teflon van Fa. Interflon only
Never take LIPID. See
chapter 12.