Rhosonics SDM-4 User Manual

SDM SERIES - SLURRY DENSITY METER
MANUAL

Rhosonics SDM-4 Specifications

General

Brand	Rhosonics
Model	SDM-4
Category	Measuring Instruments
Language	English

Summary

Installation

Selecting the SDM Location

Provides guidelines for choosing the optimal installation location for the SDM.

Installation of the Spool (SDM-1)

Details the procedure for installing the SDM-1 spool piece.

Weldolet Installation (SDM-2 or SDM-3)

Describes the installation process for weldolet adapters.

Installation of the Wafer (SDM-4 or SDM-5)

Explains the installation procedure for wafer-type adapters.

Installation of the SDM to the Process Adaptor

Details how to connect the SDM to its process adaptor.

Electrical Connections SDM

Covers the electrical connections for power supply and communication interfaces.

Operation

Operation via HART

Configuration

LCD Screen

HART Communication

Details how to set up HART communication and assign variables.

USB-Port

Calibration LCD Screen

Calibration Menu

S.G. x 1000 Calibration

Maintenance

Replacing / Mounting a Sensor

Provides detailed instructions for dismounting and mounting the SDM sensor.

Diagnostics & Service

Diagnostics Menu

System Status

Logging and Settings for Diagnostics & Evaluation

Collect Log Data Using USB

Distributors Calibration (For Rhosonics and Distributors Only)

USB-Port (Only Distributors and Factory)

mA Trimming

Describes the procedure for calibrating the mA output signal.

Temperature

Explains the temperature calibration process for the analyzer.

SGx1000 Calibration

Details the offset and span calibration procedures for SGx1000.

Technical Specifications

Operation Characteristics

SDM Housing

SDM Sensor

Spool / Weldolet / Wafer