1. Preface
1.1 Purpose
This manual explains the installation, configuration, operation and calibration of your Slurry Density
Meter (SDM), whenever settings are general for more models the SDM is called analyzer.
For ease of reading and understanding, the manual is organized in logical steps, divided over several
chapters and sections. Where necessary, the manual provides additional information about the above
mentioned issues, and gives you all the answers regarding ultrasonic inline concentration analysis in the
added section with Frequently Asked Questions.
1.2 Symbols and conventions
The following words and symbols indicate special messages:
This symbol indicates that failure to follow directions in the warning message could result in bodily harm.
This symbol indicates that failure to follow directions could result in damage to the equipment or loss of
information.
IMPORTANT:
This word indicates that the text that follows contains clarifying information or specific instructions.
NOTE:
This word indicates that the text that follows contains comments, sidelights or interesting points of
information.
1.3 About this manual
1.3.1 Conventions
The symbols ●, ○ and 1. indicate a step to be performed or other instructions
Text represented as [Bold] indicates the button below the screen display to be pressed
Text in ITALIC refers to text displayed on the screen display
Pages on the screen display are represented as figures.
The picture shown in the manual might differ from the picture shown on the display.
To Next Page
Loading...