Ricoh 5510L - Page 106

ERROR CODES 14 June, 2002
4-30
Code Meaning Suggested Cause/Action
6-11
G3 ECM - printing
impossible because of a
missing first line in the MMR
coding
Check for problems in the printer mechanism.
6-21
V.21 flag detected during
high speed modem
communication
The other terminal may be defective or
incompatible.
6-99
V.21 signal not terminated
within 6 s
Replace the FCU.
9-00
PIN code response because
of printer SC error
Fix and release the SC error
9-02 DMA receiving error (PLU) FCU defective, replace FCU.
9-03
Paper eject error at the last
page (with image data)
9-04
Paper eject error at the last
page (without image data)
9-05 Paper eject error
Check the printer drive components and sensors
9-06 Exceeded OBM counter OBM defective, replace OBM.
9-07
Paper non-feed or jam at the
cassette entrance
If the problem persists, replace the FCU.
9-08
Paper jam inside the
development area
If the problem persists, replace the FCU.
9-09
Paper jam in the fusing exit
area
If the problem persists, replace the FCU.
9-10
Toner end detected Toner out, replace AIO toner cartridge.
Toner end sensor defective, replace sensor.
AIO cartridge defective, replace cartridge.
AIO cartridge set incorrectly, check and re-set.
FCU defective, replace FCU.
9-12
Cover open detected during
printing
Close the cover, or check the cover sensors.
9-13
LD interlock error Replace the polygon motor
Replace the LD unit
9-14
PSU overheated Check the machine’s environment
Replace the PSU
9-17
Charge corona unit failure If the problem persists, replace the FCU.
9-20 Laser diode failure
9-22 Fusing lamp failure
9-23 Polygonal mirror motor error
9-24 Main motor failure
If the problem persists, replace the FCU.
9-29
Power pack error Check the connections
Replace the power pack or FCU
9-30 40MB memory write error
9-31 40MB memory control error
9-32 40MB memory read error
9-33 40MB fatal error
9-36 40MB retry error
Replace the 40MB memory