PAPER FEED AND REGISTRATION 14 June, 2002
3-18
3.5.2 REPLACING THE REGISTRATION ROLLER
1. Remove the rear cover. (☛ 3.1.3.)
2. Loosen the screws for the paper feed drive bracket [A].
3. Release the small pawl on the tip of the clutch [B] and remove the clutch.
4. Release and rotate the collar [C], then remove it along with the bushing.
5. Open the left side cover.
6. Remove the registration guide plate [D].
7. Remove the clip [E] (rear side).
8. Slide the registration roller toward the rear (left in the illustration). Once the
front side is freed, pull it up toward you and remove the roller.
H310R021.WMF
[A]
[B]
[C]
[D]
[E]
To Next Page
Loading...
