14 June, 2002 BIT SWITCHES
5-61
Service
Tables
5.2.6 G3-2 SWITCHES
These bit switches require an optional G3 interface unit.
G3-2 Switch 00 - Not used (do not change any of these settings)
G3-2 Switch 01
No FUNCTION COMMENTS
0-3 Not used Do not change these settings.
4 DIS frame length
0: No limit
1: 4 bytes
1: Only the first 4 bytes in the DIS frame will
transmit (set to 1 if there are communication
problems with PC-based faxes, which cannot
receive extended DIS frames).
5 Not used Do not change this setting.
6 CED/ANSam transmission
0: Enabled
1: Disabled
Do not change this settings, unless a
communication problem is caused by sending
CED/ANSam (V.34).
7 Not used Do not change this setting.
G3-2 Switch 02
No FUNCTION COMMENTS
0 G3 protocol mode used
0: Standard and non-standard
1: Standard only
1: Disables NSF/NSS signals (these are in non-
standard mode communication).
1-4 Not used Do not change these settings.
5 Use of modem rate history when
dialing using Quick/Speed dials
0: Disabled
1: Enabled
0: Communications using Quick/Speed dials
always start with the highest modem rate.
1: The machine uses the modem rate history for
communications with the same machine when
determining the most suitable rate for the current
communication.
6 AI short protocol (transmission
and reception)
0: Disabled 1: Enabled
Refer to Appendix B in the Group 3 Facsimile
Manual for details about AI Short Protocol.
7 Not used Do not change these settings.
To Next Page
Loading...
