Ricoh 5510L User Manual

BIT SWITCHES 14 June, 2002
5-40
5.2.3 PRINTER SWITCHES
Printer Switch 00
No FUNCTION COMMENTS
0 Page separation mark
0: Disabled
1: Enabled
0: No marks printed.
1: If an incoming fax requires two sheets to print,
the machine prints an "∗" inside a small box at the
bottom right hand corner of the first sheet. Then, it
prints a "2" inside a small box at the top right hand
corner of the second sheet. This helps the user
identify pages that have been split up.
1 Repetition of data when the
received page is longer than the
printer paper
0: Disabled
1: Enabled
0: The next page continues from where the
previous page left off.
1: The final few mm of the previous page are
printed at the top of the next page.
2-7 Not used Do not change the settings.
Printer Switch 01
No FUNCTION COMMENTS
0 Reset the fusing unit failure
0: Off
1: On (Clear)
When a fusing error occurs, set this bit to 1 after
fixing the problem. The machine then resets the
fusing error. Switch the machine off/on and this bit
will reset itself to 0.
1-3 Not used Do not change the settings.
4 Select fusing lamp control
0: Normal temperature control
(default)
1: Low temperature
After a long continuous print on paper with a
narrow main scan width, offset can occur in the
next job if the next job is on paper with a wide
main scan width, or due to differences in the length
of the interval between sheets, the number of
sheets, and the quality of the paper.
The 1 setting is intended for users that run
successive print jobs with a wide variety of paper
sizes and types. Otherwise, do not change this
setting.
5-7 Not used Do not change the settings.
Printer Switch 02 - Not used (do not change any of these settings)

Ricoh 5510L Specifications

General

Brand	Ricoh
Model	5510L
Category	Fax Machine
Language	English