Ricoh 5510L - Component Layout; Mechanical Components

14 June, 2002 COMPONENT LAYOUT
Spec-7
Spec.
1.3 COMPONENT LAYOUT
1.3.1 MECHANICAL COMPONENTS
No Name Description
1
MDF (Manual Document
Feeder)
Feeds non-standard size documents.
2 R0 Roller Feeds the document through the scanner.
3 R1 Roller Feeds the document through the scanner.
4 Document Feed Roller Feeds the document into the scanner.
5 Reverse Roller Allows one page into the scanner.
6 Pick-up Roller
Picks up pages of the document from the document table one at a
time.
7 R2 Roller Feeds the document through the stamp to the exit
8 Exit Roller Feeds the document out to the document tray.
9 Fusing Pressure Roller Applies pressure to the paper during the fusing process.
10 Laser Unit
Consists of the LDDR (Laser Diode Driver), focusing lens,
hexagonal mirror motor, and other laser optic components.
11 Paper Pick-up Roller
Picks up the top sheet of paper from the stack in the tray, and
feeds it into the printer.
12 Paper Feed Roller Feeds the paper towards the registration roller.
13 Bypass Unit 100-sheet optional paper feed unit.
14 Registration Roller Carries out the registration process.
15 Transfer Roller Transfers toner from the drum to the paper.
16 AIO (All-in-One) Cartridge
Consists of the toner cartridge, cleaning unit, used toner tank,
charge brush roller, development roller and OPC drum.
17 OPC Drum The latent image is written to this organic photoconductor drum.
18 Hot Roller Heat from this roller fuses the toner to the copy paper.
H310V003.WMF
1 2 4 5
6
7 8
9
10
11
12
13
14
15
16
17
18
3