Ricoh 5510L - Removing the Stamp Unit; Adjusting the Scanning Top Margin

ADF/SCANNER SECTIONS 14 June, 2002
3-10
3.2.7 REMOVING THE STAMP UNIT
1. With the ADF open, remove the exit guide (! x 2) (☛ 3.2.6).
2. Replace the stamp unit (! x 1).
NOTE: When removing the stamp unit, ensure that ink does not leak out of it.
3.2.8 ADJUSTING THE SCANNING TOP MARGIN
To adjust the scanner home position, change the following RAM data. When the
value is increased (with respect to the default value), the image on the printed copy
moves down the page.
ADF scanning:
Address: 4049C4 to 4049C5 default value: 004FH Unit: 0.1 mm
Adjustable range: 0000 to 009EH
MDF scanning
Address: 4049C6 to 4049C7 default value: 004FH Unit: 0.1 mm
Adjustable range: 0000 to 009EH
H310R009.WMF