EasyManua.ls Logo

Ricoh 5510L - Page 166

Ricoh 5510L
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BIT SWITCHES 14 June, 2002
5-44
Communication Switch 01
No FUNCTION COMMENTS
0 ECM
0: Disabled 1: Enabled
If this bit is 0, ECM is switched off for all
communications.
1 Not used Do not change this setting.
2
3
Wrong connection prevention
method
Bit 3 Bit 2 Setting
0 0 None
0 1 8 digit CSI
1 0 4 digit CSI
1 1 CSI/RTI
(01) - The machine will not transmit if the last 8
digits of the received CSI do not match the last 8
digits of the dialed telephone number. This does
not work for manual dialing.
(10) - The same as above, except that only the last
4 digits are compared.
(11) - The machine will not transmit if the other end
does not identify itself with an RTI or CSI.
(00) - Nothing is checked; transmission will always
go ahead.
Note: When enabling wrong connection
prevention, disable AI short protocol.
4 Operator call if no response is
received in reply to NSF/DIS
0: Disabled 1: Enabled
Set this bit to 1 if the user expects to receive
telephone calls at the same number that the
machine is connected to. The machine will then
alert the user if a phone call comes in.
5 Not used Do not change the setting.
6-7 Maximum printable page length
available
Bit 7 Bit 6 Setting
0 0 No limit
0 1 B4
1 0 A4
1 1 Not used
The receiving terminal informs the transmitting
terminal of the setting determined by these bits in
the pre-message protocol exchange (in the
DIS/NSF) frames.
Communication Switch 02
No FUNCTION COMMENTS
0 Burst error threshold
0: Low
1: High
If the received page has more consecutive error
lines than the threshold, the machine sends a
negative response.
The low and high threshold values depend on the
sub-scan resolution, and are as follows.
Resolution Standard Detail
Low settings 6 12
High settings 12 24
This bit is ignored if ECM is in use.
1 Acceptable total error line ratio
0: 5%
1: 10%
If the error line ratio of a page exceeds the
acceptable ratio, RTN will be sent to the other end.
This bit is ignored if ECM is in use.
2 Treatment of pages received
with errors during G3 reception
0: Deleted from memory without
printing
1: Printed
0: Pages received with errors are not printed.

Table of Contents

Related product manuals