Ricoh 5510L - Page 185

14 June, 2002 BIT SWITCHES
5-63
Service
Tables
G3-2 Switch 05
FUNCTION COMMENTS
0
to
3
Initial TX modem rate
Bit 3 2 1 0 Setting (bps)
0 0 0 1 2.4 k
0 0 1 0 4.8 k
0 0 1 1 7.2 k
0 1 0 0 9.6 k
0 1 0 1 12.0 k
0 1 1 0 14.4 k
0 1 1 1 16.8 k
1 0 0 0 19.2 k
1 0 0 1 21.6 k
1 0 1 0 24.0 k
1 0 1 1 26.8 k
1 1 0 0 28.8 k
1 1 0 1 31.2 k
1 1 1 0 33.6 k
Other settings - Not used
These bits set the initial starting modem rate for
transmission.
Use the dedicated transmission parameters if you
need to change this for specific receivers.
4-5 Initial modem type for 9.6 k or
7.2 kbps
Bit 5 Bit 4 Setting
0 0 V.29
0 1 V.17
1 0 Not used
1 1 Not used
These bits set the initial modem type for 9.6 k and
7.2 kbps, if the initial modem rate is set at these
speeds.
6-7 Not used Do not change these settings.
G3-2 Switch 06
FUNCTION COMMENTS
0
to
3
Initial RX modem rate
Bit 3 2 1 0 Setting (bps)
0 0 0 1 2.4 k
0 0 1 0 4.8 k
0 0 1 1 7.2 k
0 1 0 0 9.6 k
0 1 0 1 12.0k
0 1 1 0 14.4k
0 1 1 1 16.8 k
1 0 0 0 19.2 k
1 0 0 1 21.6 k
1 0 1 0 24.0 k
1 0 1 1 26.8 k
1 1 0 0 28.8 k
1 1 0 1 31.2 k
1 1 1 0 33.6 k
Other settings - Not used
The settings of these bits inform the transmitting
terminal of the available modem rate for the
receiving machine.
Use a lower setting if high speeds pose problems
during reception.