SERVICE RAM ADDRESSES 14 June, 2002
5-92
4000F4(H) - User parameter switch 04
Bit 0: Confidential reception report 0: Off, 1: On
Bit 1: Fax On Demand report output 0: Off, 1: On
Bit 2: Not used
Bit 3: Print failed transmission result in the journal 0: Off, 1: On
Bit 4: The way of printing other terminal information on the list/report
0: Print destination names programmed in Quick/Speed Dials
1: Print RTI or CSI
Bit 5: Reduce the size of the journal when printing it 0: Off, 1: On
Bit 6: Print File Reserve Report when memory is full or paper jam occurred
0: Off, 1: On
Bit 7: Includes a sample image on reports 0: Off, 1: On
4000F5(H) - User parameter switch 05
Bit 0: Substitute reception 0: Off, 1: On
Bit 1: Memory reception if no RTI or CSI received 0: Possible, 1: Impossible
(also see system switch 11 bit 6)
Bit 2: Not used
Bit 3:High temperature standby mode 0: Off, 1: On
The machine maintains the operating temperature for 15 min after printing.
Bits 4 and 5: Restricted Access
Bit 5 4 Setting
0 0 Disabled
0 1 Enabled at all times
1 0 Enabled during Night Timer periods only
1 1 Not used
Bit 6: Fusing lamp control during energy saver mode
0: Lamp off (Level 2, Low Power Standby),
1: Standby temperature (Level 1, Fax Standby)
Bit 7: Not used (keep this bit at 0.)
4000F6(H) - User parameter switch 06
Bit 0: TTI 0: Off, 1: On
Bit 1: Not used
Bit 2: Closed network for transmission 0: Off, 1: On
Bit 3: Send the Fax Header with G4 Transmission 0: Off, 1: On
Bit 4: Batch transmission 0: Off, 1: On
Bit 5: Not used
Bit 6: ISDN SPID programming (used only in the USA)
0: Off (G4 directory No.1 and No.2 can be programmed)
1: On (G4 SPID and G4 directory no. can be programmed)
Bit 7: Not used
4000F7(H) - User parameter switch 07
Bits 0 to 1: Not used
Bit 2: Parallel memory transmission 0: Off, 1: On
Bit 3: Reduction before transmission 0: Off, 1: On
Bit 4: Not used
Bits 5 to 7: Not used
To Next Page
Loading...
