14 June, 2002 INSTALLING OPTIONAL UNITS
1-13
Installation
4. Connect the harness [D] to the SG3 board
[E] and insert the board into the SG3
connector on the OPIF board [F].
5. Reattach the bracket cover [C], then
lead the harness [D] through the 2
clamps as shown.
6. Remove the bracket assembly [G] from
rear side of the machine as shown.
H209I014.WMF
H209I015.WMF
H209I040.WMF
[D]
[F]
[D]
[G]
[E]
[C]
To Next Page
Loading...
