4. Replacement and Adjustments
Before You Begin
Precautions
• To prevent electrical shock, always switch the machine off and unplug it from its power source.
• Allow the machine to cool for at least 10 minutes. This allows the fusing unit to cool and also allows
time for the polygon mirror inside the laser unit to stop rotating.
Special Tools
There are no special tools required for disassembling the machine. However, you should have these
items:
• Standard length hex screwdriver
• Stubby hex screwdriver
• Thin radio pliers
Printing the Test Page and Reports
The table below is a quick reference to help you find how to print a report. Detailed descriptions of these
reports are provided in another section of this manual. ( p.159 "Utilities")
Keep these points in mind when you use this table:
• The User Tools menu is available for the M103. (Only the M103 has the User Tools key.)
• The Fax Maintenance menus are available for the M103 only because only this machine has the
fax feature.
• The Smart Organizing Monitor is available for all three machines for printing the Configuration
Page and Test Page.
No. Report Procedure
1 Configuration Page [User Tools] > "Report Print Set" > "Configuration Page"
2 Configuration Page
Start SOM > User Tools > select "Configuration Page" from
the List/Test list > click [Print]
41
To Next Page
Loading...
