Mode No. Function Settings
33
Image Bias
Adjustment
(Manual ID
Mode)
Adjusts the development bias voltage used in
manual ID mode. This adjustment affects all manual
ID settings. Use this SP mode to adjust the density
of pale gray areas.
0: Normal
1: Darker
2: Darkest
3: Lighter
4: Lightest
See "Detailed Descriptions - Development" for more
details.
34
Image Density
Adjustment
(ADS Mode)
✝
Selects the image density level in ADS mode.
The development bias and the exposure lamp
voltages are increased or decreased.
This adjustment affects copies made in ADS mode.
The exposure lamp setting specifies the change
relative to the base exposure lamp voltage (Vo) in
SP48, 1 step of the lamp voltage equals 0.5 V for
120 V (NA), and 1.0 V for 230 V (EU) machines.
0: Normal
1: Light
2: Dark
3: Lighter
4: Darker
See "Detailed Descriptions - Development" for more
details.
35
Total Toner
Supply ON
Time During
Toner
Near/End
Condition
Selects the toner supply motor on time after every
copy job during a toner near/end condition.
1: 10 s
2: 20 s
3: 30 s
4: 40 s
5: 50 s
6: 60 s
See "Detailed Descriptions - Toner Supply" for more
details.
This SP mode is intended for designer use only.
SP Setting Setting Dev. Bias Note
0 Normal 0 Default
1 Darkest +40 V
2 Darker +20 V
3 Lighter –20 V
4 Lightest –40 V
SP Setting Setting Dev. Bias Exposure Lamp
0 Normal 0 0
1 Lighter –40 V 0
2 Darker +40 V 0
3 Lightest –40 V +4 steps
4 Darkest +40 V –4 steps
Service
Tables
20 December 1996 PROGRAM MODES
4-15
To Next Page
Loading...
