3.5 TONER COLLECTION COIL AND TONER RECYCLING
BELT REPLACEMENT
1. Open the front cover.
2. Remove the imaging unit. (See Imaging Unit Removal.)
3. Cut the seal [A] as shown.
4. Remove the toner recycling cover [B] (2 screws).
5. Remove the bearings [C,D].
6. Remove the toner recycling belt [E].
7. Remove the toner collection coil [F].
NOTE:
When removing the toner collection coil, do not lose the rear gear
[G].
8. Replace the toner recycling belt and toner collection coil.
NOTE:
When installing a new toner recycling belt, make sure that the
belt [H] is properly positioned, as shown.
When reinstalling the toner recycling cover, make sure that there
is no gap between the toner recycle cover and the imaging unit
cover.
[B]
[H]
[E]
[F]
[C]
[E]
[D]
A219R522.wmf
[A]
A219R558.wmf
AROUND THE DRUM 20 December 1996
6-22
To Next Page
Loading...
