1.15 CREASING PAPER AFTER FUSING
- Problem -
The copy paper is creased.
- Possible Causes -
1. The fusing temperature is too high.
2. The thermistor is malfunctioning.
3. The copier is installed in humid environment.
- Action -
Decrease the fusing temperature using SP49.
No good
Is the fusing thermistor working properly?
Yes No
Check the thermistor. If the thermistor is malfunctioning, replace it.
Install the optional tray heater. The heater is available as a service part (see
Section 3 for details).
Trouble-
shooting
20 December 1996 COPY QUALITY
7-19
To Next Page
Loading...
