3.10 ERASE LAMP REPLACEMENT
1. Open the front cover.
2. Remove the imaging unit. (See Imaging Unit Removal.)
3. Open the rear cover. (See Rear Cover Removal.)
4. Remove the high voltage supply board (4 screws and 6 connectors).
5. Remove the optics cooling fan motor [A] (2 screws and 1 connector).
6. Remove the erase lamp [B] (1 screw and 1 connector) from the front of
the copier as shown.
[B]
A219R541.wmf
[A]
A219R557.wmf
Replacement
Adjustment
20 December 1996 AROUND THE DRUM
6-27
To Next Page
Loading...
