2.8 2ND MIRROR REPLACEMENT
1. Turn off the main switch and unplug the power supply cord.
2. Remove the upper cover. (See Upper Cover Removal.)
3. Move the 1st scanner to home position.
CAUTION:
To move the 1st scanner, pull the scanner belt. Do not apply
force to the scanner directly.
4. Remove the bracket [A] (4 screws).
5. Lift up the 1st scanner to remove the front 2nd mirror spring plate [B].
6. Carefully shift the 2nd mirror [C] toward the front of the machine to
remove the rear spring plate [D].
7. Remove the 2nd mirror.
8. Reassemble.
- To reinstall -
1. Place the 2nd mirror in the front and rear side plate cutouts.
NOTE:
Make sure that the reflecting surface [E] faces the lens.
2. Set the rear spring plate in the rear side plate cutout while holding the
mirror, then set the front spring plate in the front side plate cutout.
NOTE:
1) Make sure that the notches in the spring plate are positioned
as shown.
2) Do not touch the reflecting surface with bare hands.
[A]
[B]
[C]
[D]
[E]
A219R526.wmf
Replacement
Adjustment
20 December 1996 OPTICS
6-13
To Next Page
Loading...
