4.4 BY-PASS FEED ROLLER AND FRICTION PAD
REPLACEMENT
1. Turn off the main switch and unplug the power supply cord.
2. Remove the by-pass feed table.
1) Open the by-pass feed table.
2) Slide out the left shaft [A] and the right shaft of the by-pass feed table,
as shown.
3) Remove the by-pass feed table [B].
3. Remove the screw [C].
4. Slide the feed roller shaft cover [D] to the right, and remove it (1 screw).
5. Remove the paper end sensor cover [E] (1 tab).
6. Remove the sensor ass’y [F] (1 screw and 2 connectors).
NOTE:
1) Be careful not to damage the feeler when removing the sensor
ass’y.
2) When reinstalling the ass’y, ensure that the harness is not
caught on the upper guide.
[A]
[B]
A219R514.wmf
[C]
[D]
[E]
[F]
A219R515.wmf
PAPER FEED 20 December 1996
6-32
To Next Page
Loading...
