7. Remove the by-pass feed roller [A], as shown.
8. Remove the spring [B].
9. Push the friction pad [C] down and then pull it out.
NOTE:
Don’t touch the feed roller with bare hands.
- To reinstall -
1. Reinstall the friction pad, the spring, and the by-pass feed roller.
2. Reinstall the sensor ass’y.
CAUTION:
1) Handle the registration sensor with care.
2) Be sure to reconnect the harnesses.
3. Reinstall the paper end cover.
4. Reinstall the by-pass feed table.
[A]
[B]
[C]
A219R542.wmf
Replacement
Adjustment
20 December 1996 PAPER FEED
6-33
To Next Page
Loading...
