4.5 BY-PASS PAPER FEED CLUTCH, HIGH VOLTAGE
SUPPLY BOARD, AND REGISTRATION CLUTCH
REPLACEMENT
1. Turn off the main switch and unplug the power supply cord.
2. Remove the rear cover. (See Rear Cover Removal.)
3. Remove the high voltage supply board [A] (4 screws and 6 connectors).
4. Remove the bracket [B] (3 screws).
5. Remove the bearing [C].
6. Remove the spring [D].
7. Replace the by-pass paper feed clutch [E].
NOTE:
When reinstalling a new clutch, engage the notch [F] with the
stopper [G], as shown.
8. Remove the main motor [H] (4 screws and 1 connector).
9. While pulling back the hook [I], remove the registration clutch [J].
NOTE:
When reinstalling a new clutch, engage the notch [K] with the
stopper [L].
[A]
[H]
A219R545.wmf
[B]
[L]
[K]
[F]
[C]
[E]
[D]
[G]
[J]
[I]
A219R546.wmf
PAPER FEED 20 December 1996
6-34
To Next Page
Loading...
