3.9 TONER SUPPLY MOTOR ASS’Y REPLACEMENT
NOTE:
1) Do not manually rotate the new toner supply motor. Doing so may
cause damage to the motor.
2) Make sure not to touch the 6th mirror when performing this
procedure.
1. Open the front cover.
2. Remove the imaging unit. (See Imaging Unit Removal.)
3. Remove the screw securing the erase lamp unit. Hang the erase lamp
unit freely inside the copier.
4. Remove the rear cover. (See Rear Cover Removal.)
5. Remove the high voltage supply board (4 screws and 6 connectors).
6. Remove the 2 screws [A] and 1 connector [B] from the rear.
7. Remove the toner supply motor ass’y [C].
8. Replace the toner supply motor ass’y.
NOTE:
When reinstalling the toner supply motor ass’y, make sure of the
followings:
1) First connect the hooks to the holes on the front. Then replace the
screws and connectors from the rear.
2) Install the motor seal [D] to the new toner supply motor. If the seal
can not be pealed off and placed on the new motor, a new seal
should be ordered.
[B]
[A]
[C]
[D]
A219R559.wmf
AROUND THE DRUM 20 December 1996
6-26
To Next Page
Loading...
