3.3 CLEANING BLADE REPLACEMENT
1. Open the front cover.
2. Remove the imaging unit. (See Imaging Unit Removal.)
3. Remove the charge corona unit [A] (1 screw) and development case [B]
(1 screw and 1 snap [C]) from the imaging unit.
4. Remove the cleaning blade [D] (2 screws).
NOTE:
1) When removing the cleaning blade, be careful not to scratch
the drum surface.
2) When installing a new cleaning blade, apply setting powder to
the edge and surface of the cleaning blade.
[B]
[D]
[A]
[C]
A219R519.wmf
AROUND THE DRUM 20 December 1996
6-20
To Next Page
Loading...
