4.9 BY-PASS PAPER END SENSOR AND REGISTRATION
SENSOR REPLACEMENT
1. Turn off the main switch and unplug the power supply cord.
2. Remove the by-pass feed table. (See step 2 of By-pass Feed Roller and
Friction Pad Replacement.)
3. Remove the screw [A].
4. Slide the feed roller shaft cover [B] to the right, and remove it (1 screw).
5. Remove the paper end sensor cover [C] (1 tab).
6. Remove the sensor ass’y [D] (1 screw and 2 connectors).
7. Replace the by-pass paper end sensor [E] and the registration sensor [F].
NOTE:
1) Take care not to damage the feeler when removing the sensor
ass’y.
2) When reinstalling the ass’y, be careful not to get the harness
caught on the upper guide.
[F]
[B]
[A]
[E]
[C]
[D]
A219R515-2.wmf
PAPER FEED 20 December 1996
6-38
To Next Page
Loading...
