2.6 LENS DRIVE MOTOR REMOVAL
1. Turn off the main switch and unplug the power supply cord.
2. Remove the upper cover. (See Upper Cover Removal.)
3. Remove the lower left cover. (See Lower Left Cover Removal.)
4. Remove the upper left cover. (See Upper Left Cover Removal.)
5. Move the 1st scanner away from the left scale, as shown by [A].
CAUTION:
To move the 1st scanner, pull the scanner belt. Do not apply
force to the scanner directly.
6. Remove the two screws [B].
7. Slide the motor [C] as shown, and remove it (1 connector).
[B]
[C]
A219R504.wmf
[A]
A219R508-2.wmf
Replacement
Adjustment
20 December 1996 OPTICS
6-11
To Next Page
Loading...
